混凝土自上料攪拌車廠家磨合期這些問題不應忽視！
小型混凝土攪拌車又被小型三輪攪拌車，具有進料快、卸料干凈殘余率少，車輛整體重 心低并且發生故障率小，攪拌罐罐體采用優良高合金鋼耐磨材料制作，有效降低磨損，簡單易維護，即使清洗罐體內部也很簡單，操作方便，合理造型，匹配型動力組合，省油，承載能力強等特點。
The small concrete mixer is also used by the small three wheel mixer, which has the advantages of fast feeding, clean discharge, less residual rate, low overall center of gravity and low failure rate. The mixing tank body is made of excellent high alloy steel wear-resistant material, which can effectively reduce wear and easy maintenance. Even if the tank body is cleaned, it is also very simple, easy to operate, reasonable modeling and matching power combination, It has the characteristics of energy saving, fuel saving and strong bearing capacity.
每位司機朋友都知道我們購買的新車剛開始都會有一個階段的磨合期，這個階段是我們需要注意保養車輛的時候。而我們購買新的小型混凝土攪拌車也不可避免的也有這個階段。
Every driver knows that the new car we buy will have a running in period at the beginning. This stage is when we need to pay attention to the maintenance of the car. And we buy new small concrete mixer also inevitably have this stage.
那么混凝土自上料攪拌車廠家就給大家講解一下新購入的小型混凝土攪拌車在磨合期時，需要注意的一些問題：
Then the manufacturer of concrete self loading mixer will explain to you some problems that need to be paid attention to when the newly purchased small concrete mixer is in the running in period
1、新購買的小型混凝土攪拌車，使用半個月之后我們需要整車的固定螺栓緊固一遍，看看有沒有松動的，特別是連接副梁和底盤之間的“U型”螺栓，其次是減速機與罐體之間的螺栓，緊固時，擰緊力矩應達到300-350Nm。
1. For the newly purchased small concrete mixer, after half a month's use, we need to tighten the fixed bolts of the whole vehicle to see if they are loose, especially the "U" bolts between the auxiliary beam and the chassis, followed by the bolts between the reducer and the tank. When tightening, the tightening torque should reach 300-350nm.
2、小型混凝土攪拌車的液壓系統也是非常重要的，液壓系統在我們初次使用250小時后要更換高壓、抗磨液壓油；并做到以后每累計使用到達2500小時左右就要更換一次，換油的時間間隔多不得超過一年，換油的同時較好更換散熱器濾芯。
2. The hydraulic system of small concrete mixer truck is also very important. The hydraulic system should be replaced with high-pressure and anti-wear hydraulic oil 250 hours after our first use; In the future, it should be replaced every 2500 hours. The oil change interval should not exceed one year at most. It is better to replace the radiator filter element at the same time.
3、減速機初次使用250小時要更換重負荷的齒輪油，以后每隔2500小時更換一次，但是換油時間不得超過一年。
3. The gear oil with heavy load should be changed 250 hours after the reducer is first used, and then every 2500 hours, but the oil change time should not exceed one year.
4、小型混凝土攪拌車的攪拌罐每次卸完料都須用水清洗罐體內外及進出料裝置，以防罐內粘過多的混凝土，一般在三個月左右就要進行一次徹 底的清理。
4. The inside and outside of the mixing tank and the feeding and discharging devices of the small concrete mixer truck must be cleaned with water after discharging each time, so as to prevent too much concrete sticking in the tank. Generally, a thorough cleaning should be carried out in about three months.
5、散熱器溫控開關是自動控制風扇的運轉和停止的，不要隨意的調動。小型攪拌車
5. Radiator temperature control switch is to automatically control the operation and stop of the fan, do not randomly adjust. Small mixer
6、在小型混凝土攪拌車正常使用過程中，當散熱器真空表讀數超過0.03兆帕?xí)r，應立即更換液壓油和濾芯。罐體檢查孔，就是“人孔”用于罐體內部維修的，必要時，可打開放出罐內的預拌混凝土。
6. In the normal use of small concrete mixer, when the reading of radiator vacuum gauge exceeds 0.03 MPa, the hydraulic oil and filter element should be replaced immediately. The manhole is used for the internal maintenance of the tank. If necessary, the ready mixed concrete in the tank can be opened and discharged.
7、托輪、卸油轉軸、操縱系統等主要部件每周都需要加注潤滑油，保障其靈活性。
7. The supporting wheel, oil unloading shaft, control system and other main parts need to be filled with lubricating oil every week to ensure their flexibility.
8、罐體檢查孔，就是“人孔”用于罐體內部維修的，必要時，可打開放出罐內的預拌混凝土。
8. The manhole is used for the internal maintenance of the tank. If necessary, the ready mixed concrete in the tank can be opened and discharged.
9、小型混凝土攪拌車攪拌罐導軌與托輪之間的接觸面每周需要加注潤滑油。
9. The contact surface between guide rail and supporting wheel of small concrete mixer needs to be filled with lubricating oil every week.
10、連接底盤和液壓泵之間的傳動軸應每周加注潤滑油。
10. The transmission shaft connecting the chassis and the hydraulic pump should be filled with lubricating oil every week.
感謝您的閱讀，希望以上內容對您有所幫助，如您想了解更多精彩內容請點擊我們的官網：混凝土自上料攪拌車一臺http://www.jbckj.cn。
Thank you for reading, I hope the above content is helpful to you, if you want to know more wonderful content, please click our official website: how much is a concrete self loading mixer http://www.jbckj.cn .
