當前位置：首頁 »新聞中心 » 常見問題全自動攪拌車廠家如何清理它的散熱器？

全自動攪拌車廠家如何清理它的散熱器？

來源：http://www.jbckj.cn 瀏覽：0發表時間：2021-06-17

全自動攪拌車廠家的散熱器在使用過程中，會因腐蝕和積垢等原因影響冷卻效果。清洗散熱器，去除水垢，是恢復散熱器的散熱能力的有效方法。車用柴油機進行維護時，必須清洗發動機的冷卻系統。若水垢不多，可用水強 力沖洗。此時散熱器和發動機水套的沖洗應分開進行。

In the process of using the radiator of automatic mixer manufacturer, the cooling effect will be affected due to corrosion and scaling. Cleaning the radiator and removing scale is an effective way to restore the heat dissipation capacity of the radiator. When the vehicle diesel engine is maintained, the cooling system of the engine must be cleaned. If there is not much scale, it can be washed with water. At this time, the radiator and engine water jacket should be washed separately.

預先將節溫器拆下，并將汽缸蓋上出水彎頭的旁通孔堵塞，用專門的沖洗槍?zhuān)诠┤胨耐瑫r(shí)，供入壓縮空氣，則沖洗效果較好。沖洗水流的方向應和發動機工作時，水的循環方向相反。為減少水垢，在冷卻系統中盡量是添加軟水;在低溫下使用，添加防凍液。

Remove the thermostat in advance, block the bypass hole of the outlet elbow on the cylinder head, and use a special flushing gun to supply water and compressed air at the same time. The direction of flushing water flow should be opposite to that of water circulation when the engine is working. In order to reduce scale, soft water should be added to the cooling system as much as possible; Use at low temperature, add antifreeze.
全自動攪拌車廠家

如果全自動攪拌車的散熱器水垢較多，則應采取化學除垢劑清洗。即利用酸或堿類物質與水垢的化學反應，生成可溶于水的物質將水垢。清洗時，采用循環法，即先用酸性溶液洗滌，再用堿性溶液沖洗中和。清洗時，除垢劑以一定的壓力(一般為10l(Pa)，在汽缸體水套或散熱器內循環，一般經3～5min后即可清洗完畢。清洗散熱器時，清洗水套、散熱器的溶液和清洗方法。

If the radiator of automatic mixer has more scale, chemical detergent should be used for cleaning. That is to say, the scale can be removed by the chemical reaction of acid or alkali substance with scale to produce water-soluble substance. When cleaning, the circulation method is adopted, that is, the acid solution is used to wash first, and then the alkaline solution is used to wash and neutralize. When cleaning, the descaling agent circulates in the water jacket or radiator of the cylinder block at a certain pressure (generally 10L (PA)) and can be cleaned after 3-5min. When cleaning the radiator, clean the water jacket, radiator solution and cleaning method.

感謝您的閱讀，希望以上內容能對您有所幫助，如您想了解更多精彩內容請點擊我們的官網：全自動攪拌車廠家http://www.jbckj.cn。

Thank you for reading, hope the above content can help you, if you want to know more wonderful content, please click our official website: automatic mixer manufacturer http://www.jbckj.cn .

下一篇：混凝土自上料攪拌車廠家液壓缸外泄漏的處理？上一篇：混凝土自上料攪拌車濾芯的質量取決什么？