影響自上料攪拌機使用年限的是什么？
1.吊桿是加料攪拌器重要的結構部件。一旦吊桿損壞或使用壽命結束，喂料攪拌器就失去了原來的意義。泵車沒有吊桿，我想只能叫車泵。因此，吊桿的使用壽命直接決定了加料攪拌車裝載部分的使用壽命。
1. The boom is an important structural component of the charging mixer. Once the boom is damaged or the service life is over, the feed mixer loses its original meaning. The pump truck has no boom. I think I can only call the pump truck. Therefore, the service life of the boom directly determines the service life of the loading part of the charging mixer truck.
2.臂架的使用壽命長取決于臂架采用高強度鋼，采用較輕的設計，并優化泵送系統的壓力，減少泵送混凝土對臂架的影響。同時，對手臂的日常保養和保養，也是提高手臂使用壽命的關鍵。因?yàn)楦鼡Q手臂的費用太高，所以，當多節手臂在出現損壞時，有些人寧愿選擇放棄對其進行保養。在那一點上，自裝混合器的生命結束了。
2. The long service life of the boom depends on the use of high-strength steel and lighter design, and optimize the pressure of the pumping system to reduce the impact of pumping concrete on the boom. At the same time, the daily maintenance of the arm is also the key to improve the service life of the arm. Because the cost of replacing the arm is too high, some people prefer to give up maintenance when multiple arms are damaged. At that point, the life of the self-contained mixer is over.
3.底盤從進料混合器的重要性是不言而喻的，如果底盤不能正常工作，也不能為安裝的液壓系統提供動力，這時，也只能選擇報廢。要延長底盤的使用壽命，關鍵的還是定期保養。同時，一些壞習慣應該避免在日常駕駛。例如，空轉的出租車，對于泵車等重車來說，是對變速箱非常損壞的。因此，底盤的使用壽命也可能與駕駛員的駕駛方式有關。
3. The importance of the chassis from the feed mixer is self-evident. If the chassis cannot work normally or provide power for the installed hydraulic system, it can only be scrapped. To prolong the service life of the chassis, the key is regular maintenance. At the same time, some bad habits should be avoided in daily driving. For example, an idle taxi is very damaged to the gearbox for heavy vehicles such as pump trucks. Therefore, the service life of the chassis may also be related to the driving style of the driver.
全自動攪拌車廠家分享變速箱的保養1. 正確把握自動上料攪拌車變速箱油的使用周期，定期更換。一般情況下，大多數廠家都會建議變速器換油周期一般為2年或4萬6萬。當使用車主朋友保持傳動油的清潔,因?yàn)樽兯傧溆褪褂煤荛L(zhǎng)一段時間后會發生油垢,可能會形成污泥,會增加摩擦磨損的部分,還會使身體運動的閥體,液壓控制,使自動混合汽車變速器異常。
Maintenance of transmission 1 Correctly grasp the service cycle of gearbox oil of automatic feeding mixer truck and replace it regularly. Generally, most manufacturers will recommend that the oil change cycle of the transmission is generally 2 years or 40000 to 60000 km. When using the vehicle owner's friend, keep the transmission oil clean, because the transmission oil will produce oil dirt after being used for a long time, which may form sludge, increase the friction and wear parts, and make the body move the valve body and hydraulic control, making the automatic hybrid vehicle transmission abnormal.
2. 經常檢查變速器油位是否正常。檢查傳動油需要預熱50℃左右,然后把桿在每一站停車后2秒,目前正常的油位應位于和之間的線,如果沒有達到,應及時添加相同的油質量。
2. Always check whether the transmission oil level is normal. Check that the transmission oil needs to be preheated to about 50 ℃, and then stop the rod at each station for 2 seconds. At present, the normal oil level should be between the highest and lowest line. If it is not reached, the same oil quality should be added in time.
3.正確更換變速箱油。動態換油目前更提倡換油的方法,選擇特殊的齒輪箱清洗設備,在傳播的過程中工作,舊的油將完整的循環,排出干凈然后參與新變速器油,這樣換油率高達90,以確保的換油。
3. Replace the transmission oil correctly. At present, dynamic oil change advocates the method of oil change. Select special gearbox cleaning equipment to work in the process of transmission. The old oil will circulate completely and be discharged, and then participate in the new transmission oil. In this way, the oil change rate is as high as 90 to ensure efficient oil change.
