當前位置：首頁 »新聞中心 » 公司新聞自上料攪拌車離合器不分離怎么辦？

自上料攪拌車離合器不分離怎么辦？

來源：http://www.jbckj.cn 瀏覽：0發表時間：2022-04-22

　　自上料攪拌車的零部件都是很重要的，如果不好好維護好就會出現問題，可能會導致攪拌車的不能使用。那么自上料攪拌車離合器不分離怎么辦？

　　Since the feeding mixer parts are very important, if not well maintained, there will be problems, may lead to the mixer can not be used. So since the feeding mixer clutch does not separate how to do?

　　要先檢查下離合油殼里的剎車油是否夠用，如果油不夠，離合怎么可能會生效？如果油量檢查正常，那么先上車多踩幾腳離合，看是否掛檔有，那么是因?yàn)殡x合油路中存在空氣，先排空氣再試試。

　　First check whether the brake oil in the clutch oil shell is enough. If the oil is not enough, how can the clutch take effect? If the oil check is normal, then first get on the car and step on a few feet of clutch to see if there is gear, then because there is air in the clutch oil road, exhaust air and try again.

　　如果油夠的活，請檢查離合總泵、離合分泵四周有無漏油現象，自上料攪拌車廠家認為如果有漏油，在不考慮維修，只單單考慮問題的情況下，更換漏油的分泵或總泵處理。

　　If the oil is enough to live, please check whether there is oil leakage around the clutch main pump and clutch sub-pump. Since the feeding mixer manufacturer thinks that if there is oil leakage, it will replace the sub-pump or the main pump without considering maintenance and only considering solving the problem.

　　更換好漏油的總泵或分泵后，再次給離合總泵處的油殼加入剎車油；再找另外一人幫你起動一面猛踩離合踩到次數踩住不放，另一個人在下面排空氣，排完后鎖緊空氣螺絲，再重復上述流程。

　　After replacing the oil leakage of the main pump or sub-pump, add brake oil to the oil shell at the clutch main pump again; Find another person to help you start while stomping on clutch and clutch to the number of times, another person to exhaust air below, after exhaust, lock the air screw, and repeat the above process.

　　直到排到離合感覺高起來，放空氣螺絲放不出氣泡出來為止。鎖緊放空氣螺絲，同時檢查離合分泵及總泵兩者的分享推桿的自由間隙，一般為兩到三毫米左右，手感有點間隙則可。

　　Until the clutch feels high and the vent screw can't let the bubbles out. Lock the air outlet screw, and check the free clearance of the clutch sub-pump and the master pump sharing push rod, generally about two to three millimeters, if there is a gap in the hand feel.

　　自上料攪拌車離合器不分離怎么辦？以上便是問題的相關內容，如果您的攪拌車有什么問題或者您想咨詢問題，就來網站www.jbckj.cn看看吧！

　　Since the feeding mixer clutch does not separate how to do? The above is the related content of the problem. If you have any problems with your mixer or you want to consult questions, come to the website www.jbckj.cn and have a look!

下一篇：自上料攪拌車停機時的要有保障！上一篇：攪拌車的安裝與拆卸過程需注意很多事項！

產品

越野叉車

平口攪拌車

自上料攪拌車

全自動攪拌車

混凝土自上料攪拌車

資訊

自上料攪拌車離合器不分離怎么辦？

相關資訊

自上料攪拌車離合器不分離怎么辦？

相關資訊

自上料攪拌車離合器不分離怎么辦？